Product features:

1, Technical parameters

Input voltage range: DC8 ~ 32V; steady state output power: 35W; Operating Temperature: -40 ~ 105 ℃; lights output: Cold start 30% within 1 second, 4 seconds to reach 80%, 8 seconds around the rated output power; maximum input current Cold start: start current 7.0A, the stabilized current 3.5A/12V; Hot Start current: approximately 6A; has a good waterproof, dustproof, anti-vibration function; with the output open circuit, short circuit protection; with input voltage, over voltage protection function; output constant power design, the lamp wider adaptability, increase lamp life of more than 50%;

 

 2, ballast (ballast) loss of value (Ballast Loss)

This value represents the ballast itself consumes energy into heat rather than light, this value can be subtracted the total power output of power consumed by the lamp. In general, the traditional ballast ballast consume about 35W of 8W, the MD1240 ballast consumes less than 7W.

 

3, the ballast protection circuit in terms of the basic structure of system is quite sophisticated, as many as a ballast on the hundreds of pieces ranging from just more than 60 electronic components, which in addition to providing stable operation of the lamp current, the need to prevent the kinds of unexpected phenomena to destroy the ballast, the ballast so well-designed, and its protection circuit design must be very thoughtful, covers the following types of special conditions, in order to provide long-term use to ensure quality. Open / short circuit protection circuit (Open / Short Circuit Protection) lightning / surge protection (Inrush Current Protection) over voltage protection (Over Low Voltage Protection) static pressure protection (Static Prevernion) automatic recovery lighting (Auto Reset)

 

4, the ballast efficiency value (Ballast Efficacy Factor)

It is the light output ratio of this value (Ballast Factor) divided by the ballast input power value (Input Power), the seller is usually in the U.S. market this value, to weigh the various stability device efficiency advantages and disadvantages, generally 75% -83% stabilizer, and FB-06 ballast  85% or more, the higher the score, the better representative of the efficiency of the ballast.

 

5, components and plastic irrigation

FB06 ballast  United States imported British Temer IC chip, STMicroelectronics (ST) MOS, TDK SMD components imported from Japan, Zhejiang, Nanjing Chuanrui discharge tube is provided for the Japanese import of Panasonic high-voltage capacitor film capacitor, ignition coil for the United States and Australia Zhongshan . Ballast used on the market to enhance the cooling effect of filling plastic to reduce the impact of temperature on electronic components, FB06 ballast Glue in strict accordance with European standards, complete coverage of all components within the ballast to achieve the best cooling. MD1240 sealed plastic irrigation products using the best series of 1:1, and all covered in MOS tube top, fully meet the waterproof and dustproof, anti-shock effect.

 

6, the light output ratio (Ballast Factor)

values ​​can be seen in this light output using the relative effectiveness of ballast, and its value is measured by the light output ballast, lighting ballast divided by the standard under the light output value of the obtain the percentage, in general, the higher this value, the better results on behalf of light output, the ballast, shall not be less than 1.18, FB-06 ballast special emphasis on the design of high output ballast, the light output ratio of up to 1.28.